Labec M-PL-600 Instrukcja Użytkownika

www.labec.com.auLaboratory Equipment Pty Ltdemail: [email protected] Ph: 02 9560 2811 • Fax: 02 9560 61312014INSTRUCTION MANUAL

or mV measurement），press <READ> long key to change the status. When the measurement is in balance status, “”displays，the instr enument will kee

Remarks：After 1 point calibration, only the zero potential of the sensor is modified （Offset），the slope of the pH sensor is kept from last c

minutes, wait for second, press“CA L”， the instrument will recognize which buffer solution is it, display as well, wait the instrument judge pH senso

In below chart, measurement value number is 88 ， 7.00pH ，measurement time 8:28（display measurement date and measurement time alternativel

temperature value (ATC or MTC), measurement time, measurement date) will be stored in memory of the instrument. 9. Functional parameter setting Press

The instrument has self diagnostics function, during operation, relative information will be reminded by the instrument, to solve problems during usag

good quality, then recalibrate the electrode. If the error still occurs, please change the electrode and calibrate the electrode. Err9：During 2 point/

hand or metal, the static electronic will destroy the electronic part of the instrument and contaminate the input terminal of the electrode, decrease

Appendix 1 Checking method of pH linear error Input 177.48mV(pH4.00 buffer solution electrode potential simulate value)、-178.07mV(pH10.01 buffer solut

PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATION 3, Hagavish st. Israel 58817 Tel: 972 3 5595252, Fax: 972 3 5594529 [email protected] MRC.VER.0

Content 1. Introduction 4 2．Technical Data

1. Introduction We thank you for having purchased PL-600 lab pH meter。 Before using the instrument, please note that the operation instruction

2.2.9 Content of storage：number of measurement value、measurement value 、 temperature value 、 ATC or MTC status、measurement date、measurement time

In above picture： Icon ①：RS232 communication strument has been connected with PC, When this icon displays, the inthe PS232 communication fu

MTC icon：the temperature displays is manual entered, pH manual ure displays is actual measurement value, pH temIc n Cal1、Cal2、Cal3： on Icon icon

Under the functional parameter setting condition, is used to modify the setR mperature setting key（decrease）、short key（press the key <1.5s）to back

Under pH measurement mode, immerse the sensor into the sample after rinsing with distilled water, shaking the vessel few minutes, if the in